Simply Maya User Community

Simply Maya User Community (https://simplymaya.com/forum/index.php)
-   Maya Basics & Newbie Lounge (https://simplymaya.com/forum/forumdisplay.php?f=31)
-   -   oops. Cut leaves hole. Hole to close? (https://simplymaya.com/forum/showthread.php?t=35352)

KaisoArt 25-03-2011 08:31 PM

oops. Cut leaves hole. Hole to close?
 
1 Attachment(s)
@#$#. I've remade this item 4 times so far trying to get geometry that bevels nicely. Anyway, I made a cut and edited the object in side view unaware that the cut leaves a hole. How can I close this?

stwert 25-03-2011 08:45 PM

There's a number of ways. You could select all surrounding edges (double click on edge) and Mesh > Fill Hole, then re-introduce the divisions with the split poly tool. Or you could select the top three edges on both sides and use the bridge tool with 0 divisions, finishing up with the holes on each side with Mesh > Fill Hole. I'm sure there's other methods, but give one of those a try.

Gen 25-03-2011 08:49 PM

1 Attachment(s)
Extrude those edges across and run a merge vert to seal it up.

stwert 25-03-2011 08:53 PM

Or you could bridge all edges across and then merge the two side edges. Plenty of good options :)


All times are GMT. The time now is 02:23 AM.

Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Simply Maya 2018