curve problem
 

alright peeps. This has been bugging me for ages so I thought I'd see if you lot know what to do. Right, say I create a curve for the hull of a boat but only one half of it. I duplicate it, rotate it 180 to make it symmetrical, reverse curve direction and attach it to the original curve. It all seems alright until I try and scale the complete curve when only one half responds. But if I duplicate it, the new curve behaves normally. However, after lofting a group of these curves, I try rebuilding the NURBS shell and end up with one end detached from the other. I'll upload a pic tomoz if you can't see where I'm coming from.

Delete the curve's history after attaching.

cheers for the quick reply. Only got 5 minutes till the IT manager cuts off me net connection. I'll try that out tonight. I think I may have already done that but might have done it to the lofted surface.

btw, seen a lot of your work and am a big fan.

Thanks. :D

Well, what you are describing is exactly what happens if you do not delete the history, so I'm pretty certain that will fix it.