six sides of the cylinder splitting open like a flower
1 Attachment(s)
is there a split edge tool in maya 5? I have a 6-sided cylinder (see below piccy) and i need to have the top split apart while the bottom remains attached.....like the drawing attached
\/ like all six sides of the cylinder splitting open like a flower |
I don't think there are any tools like that, however what i would do is select all of the edges on the top, go to edit polygons -> extrude edge, then pull the edges out and scale them however youd like.. That work?
|
1 Attachment(s)
This is done with Edit Polygons->extrude edge, with curve to control how the cylinder open. Division is set to 5 to get decent curvature
But unfortunately in the extrude edge with curve, you need to select each edge and corresponding curve. |
All times are GMT. The time now is 09:36 PM. |
Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Simply Maya 2018