I have a poly question
1 Attachment(s)
hey there I am new to this site and I had a question about poly’s
so here is my question can you trim a poly??? For example lets say you have a poly wall and u want to trim it so that it has a door opening is there a way to do that without extruding ???? :confused: |
Did you try using the cut faces tool or split polygon tool, and then deleting the faces? :confused:
|
1 Attachment(s)
Ok I did this and it worked thanx !!! but now the question is, can I extrude the edge so that the sides are solids???? Or what can be done so that I don’t have this below
|
Just extrude the side edge over and merge the vertices.
:beer: |
Are they supposed to be intersecting to be able to merge the verteces????
|
What you can do is select one of the vertices (the one you extruded) and hold down the V key, then move it onto the vertex you want to merge it with, then merge.
|
Yo minymooncr, I think you need a Maya book.
|
Quote:
|
Mastering Maya 8.5
But mine's the old version 7. It's pretty good. The video tutorials here are not too bad. There are also some free ones. |
check out digitaltutors.com :attn:
|
Thank you so much jr. who you were so very helpful :attn: I really do appreciate it ;)
And thanx 2 u 2 parka ill be sure to get one soon :blush: ;) |
you could also use the append to polygon tool - just select one edge and then the opposite edge.
Hope this helps.:beer: |
Booleans!
|
Quote:
just do as jr who said and extrude and merge, or try using the append to polygon tool. |
what is wrong with booleans?
|
Quote:
|
For something as simple as a hole in a flat wall. I would boolean, fast simple and easy. If it didn't work then out comes the Cut Faces Tool.
|
All times are GMT. The time now is 01:39 PM. |
Powered by vBulletin® Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
Simply Maya 2018