HELP....

My hard disk isnt full.....54.7 GB left

Thomas Hazlett

Thanks Kurt....

It must be the center pivot....because anytime I made a new Nurbs object I would have to pull it through my image plane....It was always on the backside of the image plane.

I...

Hello,

I am doing the T Rex tutuorial, when I try to duplicate the other side....it duplicates fine, except.... It isnt connected....I have to use move tool and bring it close and then use the...

Hello,

I need some help, I am doing some modeling and everytime I go into the lattice mode and click to lattice point.....When I highlight the point that I want to pull....It doesnt do anything. I...

mike,

Where would i find the "Wired on Shaded Option" is it on the shelf?

I have the Tiefighter tutorial off of this site. I have put the references in using nurbs/plane. Everything was going well, but when I change the sphere to wireframe my reference picture goes away. I...

Thank you very much...that was it. I am sorry I am a true newbie but I enjoy this and I am determined to learn how to do this.

Help,

When I try to pick 2 side to extrude face it will only let me do one side. In the learning video it looks like they just click on each side. When I click on the next side of my cube the...

In the video, it turns from a cube to a sphere with a blue box around it and they tell you to press 3 to smooth. When I follow the same steps mine doesnt turn to a sphere it just takes the green(that...