Allrighty then; I can get a bit more advanced In the lower-left corner of your screen, just below the time slider, is a white box; that is the command line. Click in there, and type the following: move -a -_ _ Before you go nuts with that, here are a few notes: 1) DO NOT type underscores in the command line; I merely put those there becase they are variables that YOU must decide. 2) Replace the first underscore with either x, y or z, depending on which axis you want to move your selection along. 3) Replace the second underscore with any number; positive or negative. Decimals are allowed. Press enter.