After bridging the three edges. Then pick the two edges of the quarter circle and extrude them out. Then I straightened the edges and inserted som edge loops then connected them up. I'll try to put something together for you to help explain it better
didn't realize you were the guy who modeled the jerry can. ...props, thanks for the video explaination too, super cool.
I just finished watching the video, and this is what I completed.
For some reason the middle part separated from me when I extruded it, and I had to go in use the merge edge tool. So the base is flat, and does not have the curvature on the under side. I want to blame my video card for this problem, but it definitely looks good.
cheers
-C
Last edited by ipatch; 28-08-2011 at 05:00 AM.