MMM well that shouldnt happen no way, not exporting an obj out. Or any other file come to think of it.
I'd like to see the maya scene and try it myself
J
that should be simple enough since its the Taj3 from the resources section of this site (currently page 5) unless you are referring to the .obj file I made when trying to export it I did delete that particular one but I could easily export it again and send it to you if the problem re-occurs. on a side note there are UV maps provided with the file when I downloaded it and if I use those maps then the edge selection works perfectly I'm able to get the edges selected without problems and to sew them together; however, there are parts of the scene that are not mapped properly so the texture stretches and warps over some areas which is why I was mapping them out myself when I encountered these problems.
Last edited by treazon; 20-10-2011 at 09:45 PM.