Started cutting the wing up...

-Root section
-Flap
-Tip section
-Aileron
-Trim Tab
-Bulkheads
-Landing gear opening

To do on the wing...

Will be reducing some of the edges on the wing root once I have all the details added.

-nav light asm
-hinges
-wing folding mechanics
-corrugation detailing

remaining bits...

Still a lot of detail stuff to go. Like the main landing gear and gear bays details and cockpit. I have the tailwheel section completed as well as the main landing gear fuselage kicker door. The main gear and wing folding linkages will be the tough parts.

NOTE: The bulkhead edges are showing through the surface because they are very close. I set the near clip plane as high as possible but unless I zoom in closer the edges are still visible. They are under the surface and do not show in renders.