That was 3 on the NUM PAD. I went ahead and combined. I was able to combine but the radius on the fender still was coming out messed up. Even after adding edge loops to sharpen the edges. I could do a little simpler modeling but I'm dead set on doing this specific project for now. I tried to follow the a tut of a nissan Z but had a hard time following it so I passed on that and started to mess around with it myself. I'm complicated that way. Obviously NURBS curves from what I read seem to be a bit harder to work with vs polygons... Honestly the only problem I'm having is with the stupid fender flare/lip. I can make make the shape out of polygons but then I can't make the radius on the fender without it coming out messed up.