Thanks Mayaniac,

The tube itself is actually quite easy to model in poly's. I actually had most of the entire surface done in NURB's but I was converting it all to poly's and that was the last piece I had to do.

I might show the entire part in it's NURB's form. It is quite nice actually and because I can apply rounds to all the intersections it looks like a single molded part. I only modeled it as NURB's to demonstrate how easy it is to make complex surfaces in nurbs without have to worry about routing edges, but figured no one is really interested in NURB's so I was just going to quietly make the poly surface.

However, as the Scooby Doo villain would say...I would have gotten away with it too, but Dave asked to see the wires!