Thanks Dave, the references I had for that handle were kind of vague so I had to wing it a little bit. It's just a circle extruded along a curve for the wire and some cylinders and a couple torus's (tori?). But from a mile a way and going 50 mph it'll look just fine. lol
I keep putting off the handles and trigger area because my references are a bit sketchy, especially for the trigger area and I am trying to make it as accurate as I can.
But anyway all that should be left is:
- trigger area gizmos
- handle asm
- rear site asm
- tripod
- a couple of safety wires (small detail)
"If I have seen further it is by standing on the shoulders of giants." Sir Isaac Newton, 1675
Last edited by ctbram; 17-03-2012 at 09:42 PM.