Hello,

I am a bit stuck with modeling a side panel with nurbs for a car (Ford mustang shelby 1966).

What I have tried so far is using 2 long nurb planes and intersect each other, however I can't seem to get a proper likeness.

I've also did some testing on a different single nurbs plane to get the side-scoop in there but yet again the likeness is way to off.

Could anyone help me how I can get the basic shapes set up propperly for this side panel?

Thanks in advance,

Suraci

PS:

I am re-doing it as we speak and hope to upload a picture of what I got so far.


https://3.bp.blogspot.com/-ODebrKE0eo...-350H-1966.jpg

https://bringatrailer.com/wp-content/...ck_Front_1.jpg

https://www.investmentmotorcars.net/i...6gt350h/h7.jpg