Thread: Hard Edge Issue
View Single Post
# 2 12-08-2013 , 06:56 PM
ctbram's Avatar
Join Date: Jan 2004
Location: Michigan, USA
Posts: 2,998
You should be able to simply use soften / harden edges.

If this does not work then you should check to be sure you do not have flipped normals along that edge. This is a common problem especially if surfaces were joined.

If that does not work try mesh > cleanup and check lamina faces, nonmanifold geo, edges with zero length, faces with zero area.

If that does not work than I don't know what else to try.

"If I have seen further it is by standing on the shoulders of giants." Sir Isaac Newton, 1675