View Single Post
# 3 13-10-2013 , 05:58 AM
bullet1968's Avatar
Lifetime Member
Join Date: Feb 2010
Location: Australia
Posts: 4,255
Its quite simple ans I am with ctbram, there are so many ways to do this. I would however build the walls etc first, then you are left with the door opening cutouts. I wouls then select 3 faces in the cutout, there is no door frame on a floor. Then duplicate these faces, then use extrudes to create you door frame and door.


"A Darkness at Sethanon", a book I aspire to model some of the charcters and scenes