Ok guys,
I have scaled it up a bit for the printer. Having tested on a few wee models I have now modelled a plane for my 2 year old angel Kailani Its a simple Sopwith Camel aircraft, nothing special as I needed something to use to cut up and ready as a proper model kit type arrangement. I am using the printers full volume and have separated this puppy into quite a few parts. Getting it cut right and pins/postholes in it was a PITA. As far as I am aware my printer does not have a nesting function, so I will be experimenting by placing parts in my program and see if I can stack them successfully....wish me luck
bullet1968
"A Darkness at Sethanon", a book I aspire to model some of the charcters and scenes