OK, im going to edit this post just to save space. I just wanted to say that I have redone the curve completely again and open and closed it with no problems. Then I decided to use loft for the body, I set the poly count to 500 and used fill hole to fill in the top and bottom of the body. I have a question though, it is about texturing, is it better to have more faces on a peice of geometry, does it make the textures look better? Because the part where I filled the hole only has one face in it. Ill post a pic on the body and the wire, along with what happens when I subdivide the one face.
Last edited by alienscience; 14-05-2005 at 01:03 AM.