Hey there people ! I used Headus UV layout for an ongoing project. The piece i used caused some folding and ovelapping problems when i tried to layout uvs in headus software. So i had to cut in smaller pieces. Is this way right or wrong to layout uvs? I am currently back in maya and confused about how to go on. Should i stitch the pieces in maya. If so how and in which form ? If not, is there a better way i can follow and start over again

https://img864.imageshack.us/img864/391/uv1ta.jpg

https://img205.imageshack.us/img205/7735/uv2v.jpg

https://img513.imageshack.us/img513/9708/uv3a.jpg