View Single Post
# 9 01-03-2009 , 07:45 AM
Registered User
Join Date: Dec 2007
Posts: 58

Originally posted by hammer.horror
lamina faces are two faces on top of each other. you can check for these by using the clean up tool. (set it to select only and lamina faces.)

you can check if you have strange normals by selecting back-face culling. you will see through the back of a face. so if you look at your model and see through bits, you need to flip those faces.

Yea, definitely not. This continued to happen even on older projects which I know don't have two faces on top of each other... Damn...