View Single Post
# 4 25-02-2003 , 09:58 PM
Darkware's Avatar
Subscriber
Join Date: Oct 2002
Location: USA
Posts: 1,172
Yep, those are two things you can do. Why do you want to move the curve away form the object, though? If it's so that it will not be seen, just delete it. Your revolved surface will remain intact. Of course, if you plan on animating the curve to make the revolved surface deform during animation, you need to keep it. This is where Snich's solution would come in handy. I don't think you need to worry about putting it in its own layer, though. You can just Ctrl + h to hide it.


www.Darkware3D.com