View Single Post
# 25 24-12-2008 , 06:49 AM
Perfecto's Avatar
Registered User
Join Date: Mar 2007
Location: TN (USA)
Posts: 1,889
I created a cylinder and added some extrudes. Then added 3 more cylinders. The other two pieces I created by making a cube in the general shape with divisions. Then I used split polygon tool to make a round corner inside the 4 corners of the front and rear faces. Then I performed a smooth and deleted some unneccessary edge lines created from the smooth. Then I extruded inward the front and rear faces. After that, I used a non-linear bend to curve it a little.

Attached Thumbnails

Don't be satisfied with what you can do but rather strive to do the things you can't do!
Exceed Expectations!