View Single Post
# 11 19-02-2007 , 12:05 AM
Falott's Avatar
Registered User
Join Date: Jan 2005
Location: vienna
Posts: 1,095
what Radical Edward says is: your frog mesh is not a closed mesh. imagine a sphere. a sphere is closed geometry. cut it in halfs and delete one half. now you have a open mesh. your frogMesh is open. that´s why boolean doesn´t work.



just to remind you

1) first of all - allways make sure you have no nonmanifold geomtry where you want to apply a boolean operation onto.

2) both geometries must be closed meshes. and with closed i mean really watertight.

3) conform distribution of normals on the surface. all normals of both geometries must point outwards or inwards at the same time.


reading the manual might help too.


everything starts and ends in the right place at the right time.