The area will be moving, wiggling about and such. I tried a mask, but after I set the mask where I wanted it to be, I couldn't figure out how to show the whole comp again... (See image)
EDIT: Figured out how to show it, now how do I make it so that the mask controls the effect coverage? Cause right now the mask is doing nothing.
EDIT: Figured it all out:
First duplicate the layer you are going to be applying the effect to (Control+D).
Next set up a mask on the layer on topmost layer, make sure that the box beside the word "Mask" is set to "Add".
Then set up your effect.
I think that's it... See screenshot.
Last edited by Acid44; 02-10-2010 at 11:54 PM.