Thread: Dog Model
View Single Post
07-12-2010, 03:40 PM   #1
Vox520
Subscriber
 
Vox520's Avatar
 
Join Date: Sep 2008
Posts: 3
Dog Model
After finishing the tutorial on how to model a dog, I went to convert from polygons to subdiv, yet nothing was happening. I then went back to before I joined the two halves and it worked perfectly. I have adjusted the slider to the maximum value and still nothing. This might mean that there is to much geometry?

I was planning on rigging this model in the future, so if anyone could assist me with this problem it would be appreciated.
  Reply with quote