View Single Post
31-03-2012, 03:10 PM   #2
ctbram's Avatar
Join Date: Jan 2004
Location: Michigan, USA
Posts: 2,997
default key combos for snapping have not changed between versions and they are...

you press and hold a key and then middle mouse gesture over the thing you are snapping too...

press and hold the following keys to select the target of the snap

c-key for curves
v-key for verts
x-key for the grid

so to snap a set of verts to a curve you'd

1. select the verts
2. then press and hold the c-key and the move manipulator will change to a circle at the center to indicate snapping is on
3. while still holding the c-key move the cursor to the curve you wish to snap too and then press the middle mouse button and this is VERY IMPORTANT gesture or stroke the cursor over the curve
"If I have seen further it is by standing on the shoulders of giants." Sir Isaac Newton, 1675

Last edited by ctbram; 31-03-2012 at 03:13 PM.
  Reply with quote