View Single Post
# 2 23-01-2015 , 04:00 AM
Gen's Avatar
Super Moderator
Join Date: Dec 2006
Location: South FL
Posts: 3,522
Check out Mesh>Cleanup. On the first run, its probably a better bet to set operation to select the matching polygons so at least if there are problem areas you can take notes on what to avoid. Then you can run it again but in cleanup mode instead of select, or manually go in an edit the model, up to you. It's a good habit to check the mesh integrity anyway.


- Genny
__________________
::|| My CG Blog ||::
::|| My Maya FAQ ||::