View Single Post
# 4 27-12-2004 , 05:16 PM
blomkaal's Avatar
Subscriber
Join Date: May 2004
Location: Denmark
Posts: 816
Both of these methods are useful, but they may not nessacerily give you a straight line, but a line that goes through the exact middle (or 1/3 or so depending on what percentage you choose)...

A way to do it could be to create the line, select the CV's and snap them to the grid in the direction that is normal to the line you want to create (if the line goes along the x or z axis, snap to y and so on) or scaling down in that axis... It might need some tweaking moving the line around and rotating it a little, but the line should get you a completely straight line... The Cut Faces Tool is another option, just select the faces or object you want to cut though and give 'em hell...

Hope this makes sense...