Thread: IK Trouble
View Single Post
# 3 16-09-2006 , 11:25 AM
arran's Avatar
Registered User
Join Date: Dec 2005
Location: Brooklyn, NY
Posts: 3,708
hey - I had the same problem a few days ago on the same chapter!

After doing a search on the autodesk discussion groups I found the solution.

here's a quote and the link -

After orient constraining the control joints to the reverse foot, you need to change the "Constraint Attributes / Offset" value of the orient constraints. This can be done by selecting the constraint (in the Outliner), it is created directly under the corresponding joints in the "pelvis" hierarchy; opening the Attribute Editor, and changing the value from 0 to 180. Do this for your 4 orient constraints (if you follow the book you create 2 for each leg). The selection order indicated by the book is correct though, first select the control joint, then shift-select the leg chain joint.

https://discussion.autodesk.com/threa...sageID=5286752

it seemed to work for me.

user added image


arran3D

arran3D blog