View Single Post
# 115 16-09-2005 , 09:21 AM
utpal's Avatar
Registered User
Join Date: Feb 2005
Location: india
Posts: 203

and since we are on the subject....

Also, you should make use of magnets in the ‘Edit Polygons>Split Polygons Tool>Options’ while splitting your polygonal faces. Magnets are actually the number of divisions per edge that you are splitting. Magnet Tolerance specifies how sticky your magnets are going to be. So that if you have kept the number of magnets to 1, then you split will happen either at the exact center of the edge you are splitting or, at the two extreme ends.

I hope I am making sense and don’t sound too confusing…
:p

Attached Thumbnails

Last edited by utpal; 16-09-2005 at 09:26 AM.