View Single Post
# 40 01-04-2005 , 11:22 PM
mhcannon's Avatar
Subscriber
Join Date: Sep 2004
Location: Waianae, HI
Posts: 1,275

Lofting from an Isoparm placeholder

This tip courtesy of Bubbleme80;

1. Switch to isoparm mode, select then drag an isoparm (as if you were preparing to insert an isoparm)
2. Shift select the curve (you could also loft to an isoparm on another surface)
3. Loft
4. An added benefit of this is that the original surface becomes a control object of the lofted surface. (similiar to an extrusion control curve)

Note: you can transform the loft surface indepently



AIM: mhcannonDMC

"If you love your job, you'll never work another day in your life."

Last edited by mhcannon; 01-04-2005 at 11:24 PM.