View Single Post
25-08-2011, 01:21 AM   #6
ctbram
Moderator
 
ctbram's Avatar
 
Join Date: Jan 2004
Location: Michigan, USA
Posts: 2,997
Personally, I would start with the cylinders. Delete all but the top faces. Then cut the center one into quarters and just build 1/4 of the caster base by combining the quarter face and the whole face and then use a combination of bridge and append to polygon and extrude and target weld verts to fill in the gap and go from there...



From there it is just a couple extrudes to get to here ...

__________________
"If I have seen further it is by standing on the shoulders of giants." Sir Isaac Newton, 1675

Last edited by ctbram; 25-08-2011 at 03:13 AM.
  Reply with quote