Hi all,

Here's another of my little oddities. I'm using rigid binding on a hand with lattice flexors applied to the joints.

Once the thing is set up, I find that the flexors on some of the joints invert their middle sections when the joint moves within the first 0.1 degrees or so away from the zero position. After that the flexors flip back to normal and behave properly. Picture attached.

Has anyone else come across this? Is there a solution?

I've tried removing the lattices and replacing them, but I still get the same problem. I've also tried fiddling with the settings, but to no avail.

Many thanks,

Julian