View Single Post
# 5 11-02-2003 , 10:44 PM
ragecgi's Avatar
Registered User
Join Date: Sep 2002
Location: Minnesota, USA
Posts: 3,709
It depends on your personal preference, but I would do the same as above, only instead of the Cut faces tool, I would use the Split Polygon tool for more control over the exact placement of your "bricks". Then, select the individual brick faces, and extrude/tweak to taste.

Takes a bit longer than the Cut Faces technique, but it gives you "brick" level control of detail....


Israel "Izzy" Long
Motion and Title Design for Broadcast-Film-DS
izzylong.com