Hello,

This is a other question.
I wanted to use the planar tool to get a new surface from an curve.
I first trimmed a surface to get a hole in it and then wanted to fill that hole with an planer surface to get a flat surface.
But when I do that I get an error saying: "Error PlanarTrimSurface1 (Planer Trim Surface Node'); Failed to complete the result.

But when I use the planar tool on the original curve wich is projected on the surface. I give no error and I get an planar surface. The problem is that this curve is nog like the one projected on the surface. It's "flat".

Can Anyone give me some advice on the isue???

Thank you very very much!!!

Regards,

Arce