View Single Post
# 1 19-05-2007 , 12:02 AM
BadG3r's Avatar
Subscriber
Join Date: Jan 2007
Location: Frankfurt
Posts: 216

subD attaching problem

Hey guys!

I tried a to mirror subDs and then attaching them. My problem is that by attaching the geometry i get little spaces between the two.
incresing the threshold just f***s up the mesh and the spaces are still there.
its not a display error cause i converted it to polys and looked at border edges.

i tried everything. from duplicating attaching.

converting into polys then combining and merging the verts. but then i get a little seam/hard edge in the middle.

any guess???