View Single Post
# 2 29-11-2008 , 10:50 AM
jsprogg's Avatar
Lifetime Member
Join Date: Feb 2004
Location: Chicago
Posts: 1,712
You can use a photo to texture the face however it is rare that you could use the entire photo without some copy/pasting.
A good way to start would be to use the liquify tool in PS to push the phot into position on the UV map and see where you stand after that, you will almost certainly have some minor stretching so you can then use either the clone tool and cut and past parts of the photo to fix the offending areas.This may or may not be sucessful depending on your UV layout and you might have to take addtional photos also to get the result you are after.

hope this helps a little regards J.S.




2 x Modeling Challenge Winner