Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
Even though the command feedback shows birail surface created kind of statement, there is no surface visible.... even though the outliner shows the existence of such a surface...
after the first birail surface was created and was visible... i cannot create any more surface...
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off