advice on tessellation

Integrating 3D models with photography

Interested in integrating your 3D work with the real world? This might help

Watch

# 1 11-01-2009 , 06:20 PM

Registered User
Join Date: Feb 2005

Location: This Place

Posts: 220

hey - I'm working on a machine model, and I'm trying to set it up so I can smooth parts afterwards. This means, of course, that I have to have extra topology in certain areas, to keep edges and such. However, I've come to an area where if I leave the extra topology in, the normals generated (before and after smoothing) create an extra 'highlight'. Leaving it out, causes the edges to dissappear, of course. In the attached picture, I'd like to remove the outer two of the three-set of lines adding definition to the cylinder.
Any thoughts?

Stephen

Attached Thumbnails

Click image for larger version

Name: temp.jpg
Views: 202
Size: 63.9 KB
ID: 41236

Book Wise

https://X4nd5r.deviantart.com

Quote

# 2 12-01-2009 , 12:48 AM

Registered User
Join Date: Oct 2007

Location: IL

Posts: 738

If you're obsessed about keeping the geometry as clean as possible it will be very hard.
I would do something as described in the attached pic, but it may stand out a bit. see how it looks after you smooth the edges and go on from there.

Something else you should know is that you don't have to plan the entire geometry in advance. You can model the basic shape and add geometry with various tools, such as bevel and add edge loop tool which you could have used here.

Benny

Attached Images