Maya 2020 fundamentals - modelling the real world
Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
# 1 01-02-2007 , 04:41 AM
Registered User
Join Date: May 2006
Posts: 64

Simple pole vector help.

How does one twist the pole vector with out twisting the IK-chain. If I have a T figure palm down, and Maya decides to bend along my Z access in the negative(not the direction I want) direction thus bending my arm backwards, how do you fix this? If I change my twist or pole vector settings the arm will rotate 180 degrees allowing it to bend in the the correct direction. This is good however the palm of my hand is now pointing up? Kind defeats the purpose. So how does one rotate the direction of bend with out rotating the actual IK-change.

# 2 01-02-2007 , 06:27 AM
NeoStrider's Avatar
Registered User
Join Date: Jun 2004
Location: Cleveland, Ohio (USA)
Posts: 1,541
unbind. put a natural bend in your skeleton (have your arm bend a little towards where you want it to actually bend). rebind.


Accept no substitutions.
# 3 01-02-2007 , 06:52 AM
Registered User
Join Date: May 2006
Posts: 64
So it calculates the bend based on the joint, but cant be adjusted after the bind. Got it thx.

Posting Rules Forum Rules
You may not post new threads | You may not post replies | You may not post attachments | You may not edit your posts | BB code is On | Smilies are On | [IMG] code is On | HTML code is Off

Similar Threads