Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
First when i had not selected a subdiv i could not see the cage, but now it's always on... where can i turn this of so i don't see the polygons anymore, except when i select poly's ? :headbang:
Ummm... well den, you might still have a polygon there. Did you start making the model in polys? if so, then you might have had the replace mode on. What you have to do is to delete the origional poly.
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off