Maya 2020 fundamentals - modelling the real world
Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
# 1 12-04-2007 , 05:51 PM
Rhetoric Camel's Avatar
Subscriber
Join Date: Dec 2006
Location: Plattsburgh New York
Posts: 1,222

poly to subd question

Is it necessary to go from poly to subd's when you can just get the same smoothed look by going to Edit Polys>Normals>Soften/Harden option box? If you mess up the poly to subd and back to poly's and save the process you kind of screw yourself. Where using the soften/harden even if you save and close out you can come back later and harden the edges if needed.

Just curious as to the need for subd's, and if you use 'em. I noticed Kurt uses them like they're going out of style.

# 2 12-04-2007 , 05:56 PM
jsprogg's Avatar
Lifetime Member
Join Date: Feb 2004
Location: Chicago
Posts: 1,712
it's not essential you convert to subdiv at all. You can smooth the model under the polygons/mesh menu.You can also use a poly proxy mesh as a reference to what the final smoothed mesh will look,Kurt uses subd in his workflow because he likes the extra control you can get when tweeking but if you prefer to tweek just in poly then thats your perrogative.
The bottom line is whatever works for you is ok.
Modeling can be done entirely in Nurbs, polygons or sub division surfaces or any combination of these there are no rules as long as you end up with what you need to make.


Last edited by jsprogg; 12-04-2007 at 06:05 PM.
Posting Rules Forum Rules
You may not post new threads | You may not post replies | You may not post attachments | You may not edit your posts | BB code is On | Smilies are On | [IMG] code is On | HTML code is Off

Similar Threads