Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
Hello. I did a mistake while I was attaching the leg to the body and I tried to amend my mistake deleting some faces and extruding others, the result looks good at first but when I see it in smooth mode I see the problem:
I could be a case of flipped normals. When in doubt, uncheck two sided lighting under the panel's lighting menu. It could also have been a case of unmerged/unwelded vertices.
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off