Introduction to Maya - Modeling Fundamentals Vol 2
This course will look in the fundamentals of modeling in Maya with an emphasis on creating good topology. It's aimed at people that have some modeling experience in Maya but are having trouble with
complex objects.
#
1
03-10-2006
, 05:51 AM
Subscriber
Join Date: Nov 2002
Join Date: Nov 2002
Location: Denver, US
Posts: 48
saving selections
Is there any way, after tediously picking/selecting faces, vertices, etc.., to then save that selection and regain that selection later on, rather than having to pick through them again?
Perhaps it's not possible, since changing the geometry would then alter the existence of those selections?
Thanks.
#
2
03-10-2006
, 06:58 AM
Registered User
Join Date: Feb 2003
Join Date: Feb 2003
Location: Los Angeles
Posts: 695
However, you are correct in that if you make a set of vertices or polys, and then change the models, your sets may become invalid.
I hope this helps.
#
3
03-10-2006
, 07:28 AM
Subscriber
Join Date: Nov 2002
Join Date: Nov 2002
Location: Denver, US
Posts: 48
Posting Rules Forum Rules
Similar Threads
particles disappear after saving and reopening
by ZueB in forum Dynamics & Special Effects replies 1 on 06-02-2014
Maya 2011 not saving scenes/crashes
by danielchappelle in forum Maya Technical Issues replies 1 on 23-01-2014
Quick selections - How to store.
by mrbassman in forum Maya Basics & Newbie Lounge replies 8 on 24-12-2013
Questions about saving models
by jeremybenson10 in forum Maya Basics & Newbie Lounge replies 9 on 15-10-2011
maya not saving
by mmoore5553 in forum Maya Basics & Newbie Lounge replies 2 on 19-08-2006
Topics
Free Courses
Full Courses
VFX News
How computer animation was used 30 years ago to make a Roger Rabbit short
On 2022-07-18 14:30:13
Sneak peek at Houdini 19.5
On 2022-07-18 14:17:59
VFX Breakdown The Man Who Fell To Earth
On 2022-07-15 13:14:36
Resident Evil - Teaser Trailer
On 2022-05-13 13:52:25
New cloud modeling nodes for Bifrost
On 2022-05-02 20:24:13
MPC Showreel 2022
On 2022-04-13 16:02:13