Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
I'm making my own spitfire and i have one question.
How did you model the exhaust pipes in the front of the airplane?
I'm using the same technique as you usally do(poly ---> subD) and have practicly modelled the whole plane but i'm not sure of how to model the exhaustsystem.
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off