Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
Im guessin you could go into the Attribute Editor of a material and click the little "create" button next to specularity, transparency, etc and use those image maps... =]
Im guessin you could go into the Attribute Editor of a material and click the little "create" button next to specularity, transparency, etc and use those image maps... =]
Raul: depends on the type of material your working with... say your using a blinn:
self illumination would go into incandescance
shinyness to-> specular colour
opacityto-> transparency
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off