Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
Is there a way to get the tubes painted on a bumpy NURBS surface to all point up instead of in the direction of the normal?And to do so without having to adjust each tube individually or having it also affect the flowers, leaves, buds, etc?
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off