Maya for 3D Printing - Rapid Prototyping
In this course we're going to look at something a little different, creating technically accurate 3D printed parts.
# 1 20-11-2018 , 10:09 PM
Subscriber
Join Date: May 2014
Posts: 16

UV Mapping Haunted House Tutorial

Hi, Just a few questions. Can I just model the haunted house without moving the verts to make it look haunted and if so after I finish can I UV map the haunted house then after the fact use a deformer to make it look haunted and cartoony. Hopefully, this is understood I was just wondering. I did see a tutorial where the person models a whole house then used a lattice but the person didn't go through the unwrapping stage so yeah just wondering.

Posting Rules Forum Rules
You may not post new threads | You may not post replies | You may not post attachments | You may not edit your posts | BB code is On | Smilies are On | [IMG] code is On | HTML code is Off

Similar Threads