Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
When I insert edge loops I sometimes get a ridge where the new edge loop was inserted running up the whole model. Is there a setting i'm missing that keeps this from happening?
When I insert edge loops I sometimes get a ridge where the new edge loop was inserted running up the whole model. Is there a setting i'm missing that keeps this from happening?
Thanks.
You just need to be careful where you place your egdeloops.
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off