Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
Dude I would recommend making the breasts a little more relaxed, as right now they are a touch solid. And the clavicles at the neck base are a little sharp too, maybe just brush them over with artisan that should soften them a bit
decent progress there some guy
I should check the rear though as the lower part of the bottom looks way too low and gives a very saggy appearance. Also the waist definition around the back looks too high.
Keep at it though, you're definately improving your skills
Thanks,
The butt was really bugging me, every time i convert the subdivis to poly's (That is the way i make it) It goes like that. After a bit of pulling and pushing it'll look better.
"If Less is more then think how much more more would be..."
Here is the wireframe for anyone interested.
The geometry is a bit messed up around the shoulder area and the lower back. i am not sure weather i should start again and make a cleaner mesh?
"If Less is more then think how much more more would be..."
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off