Get halfway through a model and find it's an unworkable mess? Can't add edge loops where you need them? Can't subdivide a mesh properly? If any of this sounds familiar check this course out.
as far as I can see, they look good, but can u show em saparated?! its a bit difficult to see them when they are so close to another. cant imagine what the yellow mask should show
and maybe u can show us the wireframes a bit better?
thanks for the great feed back. i've attached some clearer images and also i've attached a wire frame and the image plane .
it is just one type of mask dulpicated with a simple blinn shader.
still working on it for a post card or so.
You may not post new threads |
You may not post replies |
You may not post attachments |
You may not edit your posts |
BB code is On |
Smilies are On |
[IMG] code is On |
HTML code is Off